Airforce Gunpower Condor Falcon Regulator with Dual Gauge

Airforce Gunpower Condor Falcon Regulator with Dual Gauge Proudly Designed & Made in India for the 1st time. By default, we would set these to 130 bar, if you have a specific requirement do let us know in the comments when you place the order, and we shall make sure it's set to the requested pressure. (Range is 100 bar to 200 bar) Can handle a fill of 300 bar (input pressure) (Tested to 500 bar) and regulated pressure in the range of 100 to 200 bar (min-max output plenum pressure) However, the Max working pressure should not be attempted beyond 300 bar for the fill. The regulated pressure must not be set above 200 bar. (Defeats the purpose of having a regulator with a 300-bar fill) Output range of the regulator can be internally adjusted from 100 bar to 200 bar now. We can proudly say that our regulators are the best available in the world and will do a great job on the Airforce condor, AGI Falcon and the Gunpower airguns shooting those heavier pellets at higher speeds. Dual Gauge design: Gauge shows you the output (Regulated pressure) as well as the input pressure. (Tank pressure). No more keeping track of shot counts or guessing and working hard to know the cut off pressure of your regulators. Set the regulator to the sweet spot, speed your pellets performs the best and just watch for the regulated gauge to trip below what it was set for. Foster fill nipple on the regulator for quick fill or tethering your airgun. This regulator ensures that your tank retains the quick install and disconnect feature. Larger pre chamber on our regulators in which we have combined both power and consistent shot count. Now many users would be concerned that it increases the length of pull due to the 2- and 1/2-inches length of the regulator. So, we came up with a solution for that too. Just screw on these regulators to the compact .35L CF buddy bottles (300 bar max fill) and you would be retaining your LOP. Each regulator is filled to 300 bar for 48 hours before they ship to ensure they are free of leaks. The best raw materials have been used to machine this regulator and to ensure we have a light, durable, safe and proven product. They have been chosen, designed with materials and specs to the highest tolerances for the right job. Safety is the highest priority for any of the products we manufacture. Highly recommend, you install these regulators on our .35L CF Buddy Bottles which have a 300 bar fill capacity and are compact also helps retain the Length of Pull and get more shots as the reg is set to higher output pressure. Imp Note: Sale is only for the Regulator. You will be using the factory valve assembly which installs onto the mouth of the regulator (unless you have purchased a custom valve assembly from us) and the reg then screws into the factory buddy bottle you already have. (unless you have purchased a buddy bottle of higher rating and/or capacity) [MAKE SURE TO DEGAUSS THE TANK BEFORE ATTEMPTING THE UPGRADE. ONCE DEGAUSSED, YOU SHOULD BE ABLE TO PRESS THE VALVE WITH YOUR HANDS AND THERE SHOULD BE NO PRESSURE IN THE TANK. ALWAYS DOUBLE CHECK THE SAME BEFORE YOU START WITH THE DISSASSEMBLY) Length increased post Installation on factory setup: 70mm/2.11in Plenum Volume: 21cc Contact us if you need any customization and we shall be happy to get it done for you. If you have any further query about the listed product you can email us at aadityainnovations@gmail.com